-
Super Stock SBC – Rotating Assembly Installation
We got our block and rotating assembly back from the machine shop. Time to slam them together. (carefully). Bottom End Assembly Tools Needed: Supplies Needed: Important Specs/Measurements Measure Bearing Clearances Bearing clearances for both the main and rod bearings need to be measured before anything is assembled. Depending on your measured clearances, you can order…
-
Super Stock SBC – Bottom End Machine Work
*Insert witty heading here* Before we start piecing the powerplant together we need to get all the parts ready for assembly. This page will be dedicated to the bottom end prep, the top end (cylinder heads) will be covered here. There are three main areas of bottom end prep;
-
Super Stock SBC – Valvetrain and Intake Installation
Now that the heads are on, time to install everything that goes above them. Tools / Supplies Needed Important Measurements
-
Super Stock SBC – Cylinder Head Prep and Machining
Heads are the most important part of the build. Better get them right. For this build we are going to use a set of L31 Vortec Heads. This is because;